crwdns2933947:0crwdne2933947:0
crwdns2930901:0crwdne2930901:0crwdns2933953:020crwdne2933953:0
crwdns2916016:0crwdne2916016:0
crwdns2933933:011crwdne2933933:0
crwdns2931729:0crwdne2931729:0:
Replaced HD in MacMini late 2014 with SSD. Can’t find a place to plug in the IR Sensor cable. Looks like it should go under the board, but there’s nothing there. Some photos show a open box form, but not on this mother board. For now going to leave it unhooked and see if it runs?
crwdns2933933:0491.5crwdns2936485:0crwdne2936485:0crwdne2933933:0
crwdns2931729:0crwdne2931729:0:
Now I see your plight! When you disconnected the LED/IR sensor you really did disconnect it the hard way! Compare these two images:
Your board
A good board
Carefully peel the base off of the cable connector half and then take a picture of the bottom side so we can see how the solder contacts look and post it here for us to see.
crwdns2933955:0crwdne2933955:0
crwdns2935735:0crwdne2935735:0
crwdns2935737:0crwdne2935737:0
crwdns2918042:0crwdne2918042:0
crwdns2935739:0crwdne2935739:0
crwdns2918044:0crwdne2918044:0
crwdns2935741:0crwdne2935741:0
crwdns2944259:01crwdnd2944259:01crwdne2944259:0
