My series controller wont register if I have the rumble motors connected to the pcb board but works just fine if I leave them unsoldered. I have2 doing this

When I turn on the phone it asks for the sim card, but I've already inserted it. I tried using a different sim card and my phone didn't read the other one either. What else can I try?

i put my phone in charging and after 96% of charging i take it out and i saw that it was showing 0% battery so, again i put ot on charging so it was showing 96% but when i take it out it shows 0%. after pressing volume and power button together it shows three option 1) Reboot 2) Wipe 3) connect with mi assistant. i click on reboot so after it phone turn off again and automatically start but again these three options are showing only. after doing wipe option i wipe all data of phone but then also i cant turn on the phone.

I can turn on my phone, charge my phone, feel the vibration and hear notification. But I cant see anything on my screen. Before my screen turn black, there is some black dot appear on my screen. I though it was just some bug in my phone. I came here to find a way to fix it. Thank you.

I removed the second layer of tape that was on the iMac screen. It's only afterwards I saw in a answered post I wasn't supposed to.the what are my options from this point forward. It was a 3am bright idea. So no putting it back.

I have a ceiling fan that will only run on one speed. After some research and testing, I’m fairly certain I need to replace the capacitor. I’m just having a hard time finding a matching one.

I know just enough about electrical to ask questions before it gets dangerous, so sorry for any incorrect terminology…

The markings on the old capacitor say 350v and 4uf. I know the replacement can be higher than 350v if needed, but should be exactly 4uf.

The problem I’m running into is that the old one has 3 wires (1 red, 2 white), and all of the 3-wire capacitors I’ve found so far have 3 different colored wires with 2 different uf values.

I’m assuming the red wire is the input or hot wire and the 2 white wires are the output and share the same 4uf rating. If so, can I just get a 2-wire 350v 4uf capacitor and connect the single output wire to both of the fan’s white connections? If not, is there somewhere you recommend for finding a 3-wire 350v 4uf capacitor?

When I turn on the phone it asks for the sim card, but I've already inserted it. I tried using a different sim card and my phone didn't read the other one either. What else can I try?

My battery nearly died and i need to change it