crwdns2935355:0devicecrwdnd2935355:0crwdnd2935355:0crwdne2935355:0
crwdns2935335:0crwdne2935335:0
crwdns2935381:0crwdne2935381:0
crwdns2936071:01crwdne2936071:0
Switch off the machine so that the brew group moves to the removal position.
crwdns2936071:02crwdne2936071:0
Lay the device on its side so that you can easily access the upper brewing plunger.
crwdns2936071:03crwdne2936071:0
Unscrew a total of four Phillips screws on the front and back of the brew group.
crwdns2936071:04crwdne2936071:0
Now carefully separate the front and back.
crwdns2936071:05crwdne2936071:0
Push the plunger up and out.
crwdns2936071:06crwdne2936071:0
Unscrew the Phillips screw on the brewing sieve.
crwdns2936071:07crwdne2936071:0
The crema valve is located in the bottom of the flask under a plastic cap. You should also take this opportunity to inspect and clean it.
crwdns2936071:08crwdne2936071:0
The piston must be inserted as shown, the teeth must fit into the rack. The piston then closes flush at the top.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0