Once the cable is unglued from the back of the display module, the display can flip up towards the viewfinder and laid down face down on the back of the camera. Again, use care moving the display to avoid cable damage

Support the back of the ZIF connector (in blue), to avoid flexing the cable and flip the latch opposite the display cable side up to allow the cable to release. Once the latch is released, the cable should pull out of the connector with almost no effort.

I've left the cables connected in this photo to aid reassembly order. There is a plastic midframe (yellow arrows) attached to the display assembly with the cables passing through it. Once the display cable is removed, the midframe may fall out. Set the display and midframe assembly aside.