crwdns2915892:0crwdne2915892:0
Use this guide to replace a worn-out or dead battery in your OP-Z.
crwdns2942213:0crwdne2942213:0
-
-
Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.
-
-
-
When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).
-
-
-
-
Remove the bottom plate including the rubber feet.
-
-
-
Use your fingernail or a spudger to lift the battery on the right side where the notch is.
-
To reassemble your device, follow these instructions in reverse order.
For optimal performance, calibrate your newly installed battery: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
For optimal performance, calibrate your newly installed battery: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Does anyone know if there a way to purchase this battery in Australia? the link for the battery above says not available in Australia.. Does anyone know of another source? thanks