crwdns2915892:0crwdne2915892:0
Follow this guide to replace the charging assembly on a Sony Dualshock 4 CHU-ZCT2U PlayStation controller.
crwdns2942213:0crwdne2942213:0
-
-
Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel.
-
-
-
Insert an opening tool into the crease where the front and rear panel meet, starting from the outside edge of either handle.
-
Gently pry the rear panel off of the front panel until they become partially separated.
-
-
-
Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller.
-
-
-
Lift the rear panel directly away from the controller.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use your fingers to gently pull the ribbon cable straight out of its connector on the motherboard.
-
-
-
Use an opening tool or spudger to separate the white plastic bar from the rear panel.
-
-
-
Lift the light guide away from the rear panel to remove it.
-
-
-
Use your fingers to press the translucent plastic piece down through the top of the controller.
-
Remove the translucent plastic piece.
-
-
-
Use a Phillips screwdriver to remove the 4.4 mm-long screw from the charging assembly.
-
-
-
Use the pointed end of a spudger to lift the charging assembly away from the rear panel.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use your fingers or a pair of tweezers to remove the charging assembly from the rear panel.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
crwdns2935221:0crwdne2935221:0
crwdns2935229:012crwdne2935229:0
crwdns2947412:03crwdne2947412:0
Question:
I have a ps4 controller model CUH-ZCT2U. My charging board model is jds 050.
Can I buy the jds 055 charging board and put that in? Is the jds 050 and the jds 055 charging board interchangeable?
I can't seem to find the jds 050 charging boards anywhere. Only the jds 055. Any help would be very much appreciated. Thanks.
I have not tested the JDS-055 and JDS-050 in a ZCT2U so I cannot guarantee it will work. However, visually they appear to be the same part made by a different manufacturer. I suspect that it will work, but understand that it’s a gamble and make sure the store you buy from has a good return policy like iFixit. If you can wait, add yourself to the notify list for the JDS-050 and order once they become available again.
Great guide but the correct controller model is CUH-ZCT2U. The title has it as CHU-ZCT2U.
