I have accidentally separated the keyboard Zif connector on my HP 15-n230sa laptop from the main board. Didn't realise the tab was on the opposite side of the connector and stupidly prised it off the board.
Please would you mind taking a look at the pictures and tell me whether this can be rectified? Is there anyway to reseat it back on the board?
Thanks in advance!
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 490.4crwdns2936485:0crwdne2936485:0
35
338
973
You are very lucky! The solder pads didn’t get damaged so it should be possible to re-solder the connector back down.
Now the tricky part! To do this right you need a re-work system which uses hot air. Your best bet is to find someone local to you with the needed tools to remount it.
crwdns2934105:0crwdne2934105:0
crwdns2934065:0crwdne2934065:0: 1
1
go to hit shows on utube, the fellow speaks mostly indian, but if you watch he cuts plastic to fit over the end of the ribbon and a small piece for tension on the underside and heats them and then inserts them and they hold solid.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 3
crwdns2942667:0crwdne2942667:0 193
crwdns2947414:01crwdne2947414:0
I will find some who can re-solder this for me. Thank you very much for answering my question, much appreciated.
crwdns2934271:0crwdnd2934271:0 Andrew Hawker crwdne2934271:0