crwdns2894164:0crwdne2894164:0

The UP! Plus 2 is a 3D printer manufactured by PP3DP for home or professional use and is capable of printing objects of up to 140W x 140D x 135H (mm).

crwdns2886949:03crwdne2886949:0 crwdns2858137:0crwdne2858137:0

Printer that is not initializing correctly and skipping?

I've had my printer for a while now, and I've run into an issue where my printer will start skipping and pushing it's y-limit boundary. There is no "click" of the switch in the back.

crwdns2893858:0crwdne2893858:0 crwdns2893862:0crwdne2893862:0

crwdns2894050:0crwdne2894050:0

crwdns2889612:0crwdne2889612:0 1
crwdns2892346:0crwdne2892346:0

crwdns2886779:02crwdne2886779:0

crwdns2893814:0crwdne2893814:0

If your printer is going too far back and there is no audible click then your y-limit is malfunctioning. This means your mechanical limit switch is either not connected or malfunctioned and should be replaced.

crwdns2894046:0crwdne2894046:0

crwdns2889612:0crwdne2889612:0 1
crwdns2892346:0crwdne2892346:0

make sure the firmware is updated and check the bed range settings in your slicing software.

crwdns2894046:0crwdne2894046:0

crwdns2889612:0crwdne2889612:0 0
crwdns2892346:0crwdne2892346:0

crwdns2893896:0crwdne2893896:0

Spencer Jefferson crwdns2893898:0crwdne2893898:0
crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 0

crwdns2894768:030crwdne2894768:0 0

crwdns2894770:0crwdne2894770:0 293