crwdns2934065:0crwdne2934065:0: 106
8
1
I've had my printer for a while now, and I've run into an issue where my printer will start skipping and pushing it's y-limit boundary. There is no "click" of the switch in the back.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 508
10
1
If your printer is going too far back and there is no audible click then your y-limit is malfunctioning. This means your mechanical limit switch is either not connected or malfunctioned and should be replaced.
crwdns2934105:0crwdne2934105:0
make sure the firmware is updated and check the bed range settings in your slicing software.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 0
crwdns2936753:030crwdne2936753:0 0
crwdns2942667:0crwdne2942667:0 306
