crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Remplacement de la caméra arrière du Meizu MX3

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:04crwdne2931653:0
Meizu MX3 Rear Facing Camera Replacement, Removing Extra Components: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Meizu MX3 Rear Facing Camera Replacement, Removing Extra Components: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Meizu MX3 Rear Facing Camera Replacement, Removing Extra Components: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Removing Extra Components

  • Remove the screws in the three red circles. Two of the three ribbon cables in the turquoise box will need to be removed like those above the battery. Use the pointed edge spudger to pull the third cable out to the left.

  • Insert the plastic opening tool on top the ribbon cable but below the circuit board in the yellow circle, and pry that ribbon cable free. Remove the headphone jack as see in the picture.

  • Use tweezers to disconnect the wire connector in the red box. As seen in the picture gentle insert the plastic opening tool and unhook that cable and begin to lift the circuit board.

Suppression de composants supplémentaires

Retirez les vis dans les trois cercles rouges. Deux des trois nappes du boîtier turquoise devront être retirées comme celles au-dessus de la batterie. Utilisez le spudger pointu pour tirer le troisième câble vers la gauche.

Insérez l'outil d'ouverture en plastique sur le dessus du câble ruban, mais sous la carte de circuit imprimé dans le cercle jaune, et dégagez ce câble ruban. Retirez la prise casque comme indiqué sur l'image.

Utilisez une pince à épiler pour déconnecter le connecteur de fil dans la boîte rouge. Comme on le voit sur la photo, insérez délicatement l'outil d'ouverture en plastique et décrochez ce câble et commencez à soulever le circuit imprimé.

[title] Removing Extra Components
[* black] Remove the screws in the three red circles. Two of the three ribbon cables in the turquoise box will need to be removed like those above the battery. Use the pointed edge spudger to pull the third cable out to the left.
[* black] Insert the plastic opening tool on top the ribbon cable but below the circuit board in the yellow circle, and pry that ribbon cable free. Remove the headphone jack as see in the picture.
-[* black] Use tweezers to disconnect the wire connector in the red box. As seen in the picture gentle insert the plastic opening tool and unhook that cable and begin to lift the circuit board.
+[* black] Use [product|IF145-020|tweezers] to disconnect the wire connector in the red box. As seen in the picture gentle insert the plastic opening tool and unhook that cable and begin to lift the circuit board.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0