crwdns2933423:0crwdne2933423:0

マルチメーターの使用方法

crwdns2935425:015crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:015crwdne2931653:0
How To Use A Multimeter: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How To Use A Multimeter: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Place one probe at each end of the circuit or component you want to measure.

  • It doesn't matter which probe goes where; resistance is non-directional.

  • If your multimeter is manual ranging:

  • If your multimeter reads close to zero, the range is set too high for a good measurement. Turn the dial to a lower resistance range.

  • If you set the range too low, the multimeter simply reads 1 or OL, indicating that it is overloaded or out of range. This won't hurt the multimeter, but we need to set the dial to a higher range.

  • The other possibility is that the circuit or component you are measuring doesn't have continuity—that is, it has infinite resistance. A non continuous circuit will always read 1 or OL on a resistance test.

片方のプロープを、測りたい回路か部品の片方の終端に当てます。

プロープはどこに置いても大丈夫です。抵抗には指向性はありません。

測定範囲を手動で設定するマルチメーターを使う場合、以下の点に注意して下さい。

マルチメーターの表示がゼロに近い場合、正しい測定レンジよりも高すぎます。より低いレンジに合わせてください。

もしレンジが低すぎる場合、マルチメーターは1かOLの表示をします。これは抵抗が強すぎるか計測範囲から外れていることを示しています。これはマルチメーターを傷つけるものではありませんが、ダイアルをより高いレンジに合わせるべきです。

他の可能性として、測っている回路か部品が導通していない可能性があります。これは無限の抵抗を示します。導通していない回路の抵抗値を測定すると、常に1かOLの表示になります。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0