crwdns2933423:0crwdne2933423:0

マルチメーターの使用方法

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:013crwdne2931653:0
How To Use A Multimeter, Measuring resistance: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 How To Use A Multimeter, Measuring resistance: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 How To Use A Multimeter, Measuring resistance: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Measuring resistance
  • The next three steps will show you how to measure resistance with your multimeter.

  • To begin, make sure no current is running through the circuit or component you want to measure. Switch it off, unplug it from the wall, and remove any batteries.

  • Remember that you'll be measuring the resistance of the entire circuit. If you want to measure an individual component such as a resistor, measure it by itself—not with it soldered in place!

  • Plug the black probe into the COM port on your multimeter.

  • Plug the red probe into the port labeled with an Ω symbol (in this case, the right port).

ここから3つの手順は、マルチメーターを使って抵抗値を計測する方法を説明しています。

まず、測定したい回路や部品に電流が流れていないことを確認します。電源を切り、電源プラグをコンセントから抜き、電池を取り外してください。

回路全体の抵抗値を測定することを忘れないでください。抵抗器のような個々の部品を測定したい場合は、はんだ付けした状態ではなく、単体で測定すること!

黒のプロープを、マルチメーターのCOMポートに挿してください。

赤いプローブをΩ記号のとラベル表記されたポート(この場合は右ポート)に差し込みます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0