crwdns2933423:0crwdne2933423:0

NeatDesk™ Desktop Scanner Circuit Board Repair

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
NeatDesk™ Desktop Scanner Circuit Board Repair, Disassemble Scanner: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 NeatDesk™ Desktop Scanner Circuit Board Repair, Disassemble Scanner: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 NeatDesk™ Desktop Scanner Circuit Board Repair, Disassemble Scanner: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disassemble Scanner
  • Unscrew bottom access cover.

  • Use a #2 Phillips Screwdriver and carefully remove Four (4) screws from bottom access panel.

  • It may be advisable to have a magnet handy, in the event the screws are difficult to extract due to the recessed mounting hole.

  • Open bottom access cover.

  • Use a Spudger or Suction Cup to pry open the access cover. Pay attention to provided image and be sure to tilt cover as shown to make removal easy.

  • Circuit board is mounted to other side of access cover and wiring must be disconnected before access cover is completely removed.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0