crwdns2933423:0crwdne2933423:0

Instalación de un botón de presión de metal con una prensa manual

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert the stud die into the hand press
  • Using your fingers, a screwdriver, or a hex key, as needed, unscrew the tightening mechanism on the side of the press near the die fitting.

  • Insert the die upward and hold it in place.

  • Tighten the tightening mechanism.

Usando los dedos, un destornillador o una llave hexagonal, según sea necesario, desenrosca el mecanismo de apriete en el lado de la prensa cerca del accesorio del troquel.

Inserta el troquel hacia arriba y mantenlo en su lugar.

Aprieta el mecanismo de apriete.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0