Disassembly of the Dreame L10s Ultra base station

crwdns2936071:01crwdne2936071:0 — Remove the cover

Remove the four screws from the cover. Use a Phillips screwdriver to loosen them. Be careful not to lose the screws – they are small and can easily disappear!

crwdns2936071:02crwdne2936071:0 — Remove the top cover

The top cover is held on with clips.

crwdns2936071:03crwdne2936071:0 — Remove the upper screws.

Take out the two marked screws using a PH2 screwdriver.

crwdns2936071:04crwdne2936071:0 — Remove the cover from the bottom

Remove the seven screws on the bottom of the base station with a PH2 screwdriver

crwdns2936071:05crwdne2936071:0 — Remove the screws at the bottom

Remove the two marked screws with a PH2 screwdriver.

crwdns2936071:06crwdne2936071:0 — Remove the screws at the back

Now you need to remove the cover for the seven marked screws. You can do this either with tweezers or, if you want to be sure that nothing gets damaged, with a Halberd Spudger.

crwdns2936071:07crwdne2936071:0 — Remove the cover

On both sides of the cover, the plastic hooks on my model are located at approximately the following positions, measured from the bottom:

crwdns2936071:08crwdne2936071:0 — Maintenance, repair, cleaning

Now the desired maintenance/repairs can be carried out.