crwdns2933423:0crwdne2933423:0

はんだ付けとはんだ除去の作業ガイド

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:02crwdne2931653:0
How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • To open the hole blocked by solder, heat the solder pad with the tip of a soldering iron. Push through the molten solder from the other side with a staple or sewing needle.

  • In our case, we decided to use a right angle pick. Lead solder will not stick to steel, so pretty much any thin steel can be used.

  • Pushing the tool all the way through the hole may require heating the pad several times. As a rule of thumb, heat the solder just enough for it to melt, then remove the soldering tip from the pad. Excessive heat will damage electronic components.

はんだで塞がっているホールを開けるには、はんだごての先端ではんだパッドを加熱します。裏側からホッチキスや裁縫針を押し込んで、溶けたはんだに通します。

当サイトの場合では、直角のピックを使用することにしました。鉛はんだはスチールに付着しないため、細いスチールなら問題ありません。

ツールをホールに押し込んで貫通させるには、数回パッドを加熱しなければならない場合があります。経験から言うと、はんだがちょうど溶けるまで加熱して、次にパッドからはんだごての先端を離すといいでしょう。加熱しすぎると、電子部品が損傷します。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0