crwdns2933423:0crwdne2933423:0

はんだ付けとはんだ除去の作業ガイド

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
How To Solder and Desolder Connections, Beginning Guide: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Beginning Guide
  • To start, let's solder a large component held to a circuit board with thru-hole solder pads.

  • A capacitor was already removed from the two solder pads. Each pad was heated while the capacitor was pulled away from the board.

  • Notice how the solder holes are completely covered with solder. Opening these holes so the capacitor lead can be pushed through will greatly simplify installation.

まず、スルーホールはんだパッドで回路基板に固定された大型部品をはんだ付けしましょう。

既に2つのはんだパッドからコンデンサが取り外されています。コンデンサを基板から引っ張りながら、それぞれのパッドを加熱しました。

はんだホールがはんだで完全に覆われていることに注意します。これらのホールを開け、コンデンサの足を押し込んで通せるようにすると、取り付けがかなり簡単になります。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0