crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Desmontaje de la amoladora angular Bauker PGA115G1.2

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:014crwdne2931653:0
Disassembling Bauker PGA115G1.2 Angle grinder, Remove the stator.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Disassembling Bauker PGA115G1.2 Angle grinder, Remove the stator.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Disassembling Bauker PGA115G1.2 Angle grinder, Remove the stator.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the stator.

  • You probably only need to remove the stator if it has a fault. In my case one of the leads was broken close to a coil.

  • First remove the front cover: it simply pulls out.

  • The two screws holding the stator can now been seen. As always they seem to be PH2.

  • Unscrew them: they may be quite tight.

Quita el estator.

Probablemente solo necesites quitar el estator si tiene una falla. En mi caso, uno de los cables estaba roto cerca de una bobina.

Primero quita la tapa frontal: simplemente se saca.

Ahora se pueden ver los dos tornillos que sujetan el estator. Como siempre, parecen ser PH2.

Desatorníllalos: pueden estar bastante apretados.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0