crwdns2933423:0crwdne2933423:0

Mod batteria Asus ROG Ally

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:06crwdne2931653:0
Asus ROG Ally Battery Mod, Prepare your 3D printed backplate: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Asus ROG Ally Battery Mod, Prepare your 3D printed backplate: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Asus ROG Ally Battery Mod, Prepare your 3D printed backplate: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Prepare your 3D printed backplate
  • It's a good idea to run pilot holes through any screw pillars before proceeding further.

  • Make sure to grab the light blocker from the original back cover and place it in the new shell.

  • This piece of foam covers a light sensor on the ROG Ally mainboard. If the sensor is not covered, the system will not boot.

  • Transfer the paddles and triggers from the original cover over to the newly printed back plate.

È una buona idea eseguire dei fori pilota attraverso i fori delle viti prima di andare avanti.

Assicurati di spostare il dispositivo di blocco della luce della copertura posteriore originale e posizionarlo nella nuova cover.

Questo pezzo di schiuma copre il sensore di luce sulla scheda madre del ROG Ally. Se il sensore non è coperto, il sistema non si avvia.

Trasferisci le piastre e i grilletti dalla copertura originale alla cover posteriore appena stampata.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0