crwdns2933423:0crwdne2933423:0

Ripara un Magic Mouse dopo una fuoriuscita di liquido dalla batteria

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
Repair a Magic Mouse After a Battery Leak, Remove the Aluminum Shell: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Remove the Aluminum Shell
  • If previous efforts to free the springs have failed, you need to open up the mouse to get at the hidden parts of the metal posts. Check out the separate teardown guide that someone else wrote, showing how to open up an Apple Mouse. Then come back to my guide for, well, guidance.

  • Our goal is to remove the aluminum shell covering the bottom of the mouse. Begin by removing the battery door. The two black plastic glide rails should pop right off. Remove the batteries.

  • The aluminum shell is lightly glued to the black plastic part that holds the batteries. Use a heat gun or a hair dryer set on low, to warm up the aluminum and soften the glue. Take care not to apply too much heat or you might melt the white plastic top of the mouse or the black plastic underneath the aluminum shell.

  • When the aluminum shell is warm, gently pry it up, with a plastic lever or your fingernails. Pull gently and steadily, with patience, until the aluminum shell pulls away from the black plastic base.

Se i tentativi precedenti di liberare le molle sono falliti, hai bisogno di aprire il mouse per poter arrivare alle parti nascoste dietro i poli di metallo. Controlla la guida per smontare il pezzo, scritta da qualcun altro, in cui è mostrato come aprire un mouse Apple. In seguito riprendi questa guida per essere, ovviamente, guidato.

Il nostro obiettivo è quello di rimuovere l'involucro di alluminio dalla parte inferiore del mouse. Comincia rimuovendo lo sportello della batteria. Le due guide di plastica nere dovrebbero venir via facilmente. Rimuovi le batterie.

L'involucro di alluminio è leggermente incollato al pezzo di plastica nero che tiene le batterie. Usa una pistola termica o un asciugacapelli alla minima potenza per riscaldare l'alluminio e far sciogliere un po' la colla. Attento a non usare troppo calore per non sciogliere la plastica bianca superiore del mouse o quella nera sotto l'alluminio.

Quando l'involucro di alluminio è caldo, fai leva verso l'alto con una leva di plastica o col dito. Spingi con delicatezza e sicurezza, abbi pazienza, finchè l'involucro di alluminio non si allontana dalla base di plastica nera.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0