crwdns2933423:0crwdne2933423:0

Ripara un Magic Mouse dopo una fuoriuscita di liquido dalla batteria

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:01crwdne2931653:0
Repair a Magic Mouse After a Battery Leak, Clean Battery Compartment: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Clean Battery Compartment
  • Let's not neglect the obvious. First make sure that your mouse has fresh batteries in it and that the batteries are in the correct orientation. Slide the switch on the bottom of the mouse to see if the green light comes on. If it does, the electrical contacts are good and you're done.

  • If no joy, examine all four battery contacts inside the Magic Mouse's battery compartment. Scrape off any brittle white material or corrosion until the metal contacts are mostly shiny where they contact the batteries.

  • Reinsert the batteries to see if that fixed the problem. If that doesn't work, carefully check the negative battery posts.

  • The negative end of the AA batteries are supposed to press firmly against shiny, spring-loaded metal posts. If there's too much dried battery leakage gumming up the posts, they might be partially or fully stuck under compression. If so, weak or absent spring action will cause the battery contacts to fail.

  • To deal with this, carefully scrape all of the visible dried battery residue off of the posts. Press the posts and release them several times, trying to free them up until they pop up vigorously.

  • If that doesn't work, try shooting a very small amount of WD-40 at the base of the battery posts to see if that frees them up.

Non trascurare ciò che è ovvio! Per prima cosa devi essere sicuro che nel tuo mouse ci siano batterie nuove e che siano orientate correttamente. Fai scorrere l'interruttore sul fondo del mouse per vedere se la luce verde si accende. Se succede, i contatti elettrici sono ancora buoni e hai già finito!

Se non puoi festeggiare, esamina tutti i quattro contatti delle batterie all'interno del vano batterie del Magic Mouse. Gratta via qualsiasi materiale bianco e sgretolabile o corrosione finché i contatti in metallo sono piuttosto puliti in corrispondenza dei contatti delle batterie.

Inserisci ancora le batterie per controllare se ciò ha corretto il problema. Se non funziona, devi controllare attentamente il polo negativo della batteria.

Il polo negativo delle batterie AA deve premere fermamente contro il polo a molla del contatto in metallo. Se c'è troppo liquido ormai secco e appiccicoso, i poli delle batterie potrebbero essere parzialmente o interamente bloccati sotto pressione. Se è il caso, una molla debole o assente causerà il non funzionamento dei contatti della batteria.

Per risolvere ciò, devi attentamente strofinare via i residui visibili seccati dai contatti della batteria. Premi e rilascia le molle diverse volte, fino a quando non si aprono in modo vigoroso.

Se ciò non funziona, prova a mettere una piccola quantità di WD-40 alla base dei contatti della batteria per vedere se si riescono ad aprire correttamente.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0