crwdns2933423:0crwdne2933423:0

Ripara un Magic Mouse dopo una fuoriuscita di liquido dalla batteria

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:03crwdne2931653:0
Repair a Magic Mouse After a Battery Leak, Gently Separate the Top and Bottom Halves: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Repair a Magic Mouse After a Battery Leak, Gently Separate the Top and Bottom Halves: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Gently Separate the Top and Bottom Halves
  • You have removed the aluminum shell that was glued onto the bottom of Apple's Magic Mouse.

  • What you have left with are the upper and lower halves of the mouse. They are held together by four tiny black plastic posts on the bottom half, that are inserted into plastic loops on the top half. WARNING: Proceed with caution. If you break any of these black plastic posts or loops, it might be game over.

  • The two halves are connected by a wide ribbon cable that is somewhat fragile. WARNING: If you tear this cable it is game over for this mouse.

  • Proceeding with caution, take a small pry tool and pry one of the plastic loops off of its black plastic post. Pry the loop in the outboard direction while applying gentle pressure separating the upper and lower halves of the mouse. The loop should pop off the black plastic post.

  • Continue to release each of the remaining three black plastic posts. Remember that on the Apple logo end of the mouse there is a fragile ribbon cable that you dare not tear.

  • Once you release the black plastic posts, the only thing holding the mouse together is a very fragile ribbon cable [see second photo]. WARNING: You don't want to tear the cable or pull it out of its socket (because it is tricky to put it back into the socket). Proceed with care!

Hai rimosso il guscio di alluminio che era incollato sul fondo del Magic Mouse di Apple.

Le due metà superiore e inferiore del mouse sono tenute insieme da quattro minuscoli montanti di plastica nera nella parte inferiore, che si inseriscono in anelli di plastica nella parte superiore. ATTENZIONE: procedi con cautela. Se questi montanti neri di plastica si rompono, potrebbe non esserci più niente da fare.

Le due metà sono collegate da un ampio cavo a nastro piuttosto fragile. ATTENZIONE: se si strappa questo cavo, per questo mouse è finita.

Procedendo con cautela, prendi un piccolo attrezzo per fare leva su uno degli anelli di plastica dal suo supporto di plastica nera. Fa' leva sull'anello in direzione esterna, esercitando una leggera pressione per separare le metà superiore e inferiore del mouse. L'occhiello dovrebbe staccarsi dal supporto di plastica nera.

Continua a liberare ciascuno dei tre restanti punti di plastica nera. Ricorda che all'estremità del logo Apple del mouse c'è un fragile cavo a nastro che non devi strappare.

Una volta sganciati i montanti di plastica nera, l'unica cosa che tiene insieme il mouse è un cavo a nastro molto fragile [vedi seconda foto]. ATTENZIONE: non strappare il cavo o estrarlo dalla presa (perché è difficile reinserirlo nella presa). Procedi con cautela!

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0