crwdns2933423:0crwdne2933423:0

Reemplazo de pantalla y batería de Wahoo Elemnt Roam (WFCC4)

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:011crwdne2931653:0
Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Solder Bodge Wire to Old Battery Circuit Board: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Solder Bodge Wire to Old Battery Circuit Board: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Solder Bodge Wire to Old Battery Circuit Board: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Solder Bodge Wire to Old Battery Circuit Board
  • We have to solder a bodge wire to create a permanent connection between the negative side of the old battery's circuit board and the ribbon cable.

  • Solder a small enamelled copper wire to bridge the two center pads of the IC (red circles first picture)

  • Use a multimeter to check the connection between the negative side of the circuit board and the ribbon cable

  • Add some solder to the positive and negative tabs of the board to prepare them for soldering later

  • You can also add some solder mask to the bodge wire for extra protection

Tenemos que soldar un cable bodge para crear una conexión permanente entre el lado negativo de la placa de circuito de la batería vieja y el cable plano.

Suelda un pequeño cable de cobre esmaltado para unir las dos almohadillas centrales del IC (primera imagen de círculos rojos)

Utiliza un multímetro para comprobar la conexión entre el lado negativo de la placa de circuito y el cable plano.

Agregua un poco de soldadura a las pestañas positivas y negativas de la placa para prepararlas para soldar más adelante.

También puedes agregar un poco de máscara de soldadura al cable bodge para mayor protección.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0