How to open the Saeco Moltio housing (plastic frame)

crwdns2936071:01crwdne2936071:0

First check which model you have in front of you: Is the decorative frame made of chromed metal (picture 1) or of metallized plastic? (picture 2). In the first case follow this guide, in the second case you are in the right place here.

crwdns2936071:02crwdne2936071:0

Never forget to remove the power!

crwdns2936071:03crwdne2936071:0

First, the metalized plastic decorative frame on the water tank side must be removed. It is only hold in place by clips, but it often jams so hard that you have to use a lot of force - but not so much that it breaks.

crwdns2936071:04crwdne2936071:0

Now start dismantling the top panel. First remove the two Torx T10 screws at the top of the back.

crwdns2936071:05crwdne2936071:0

Using a plastic pry tool gently disengage the top panel and lift it up and out. It might jam a little, especially under the decorative frame on the side with the service flap.

crwdns2936071:06crwdne2936071:0

Now the side part on the water tank side can be removed. It is still attached with three screws.

crwdns2936071:07crwdne2936071:0

Lay the machine on its side. Now you can lift off the side panel. There is a small notch in the top right and it is probably still a bit stuck.