crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Yellow Light of Death Repair

crwdns2936025:03crwdne2936025:0 —
crwdns2916944:0crwdne2916944:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.

Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.

This will prevent damage to the board caused by localized thermal expansion.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0