crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

How to Remove a Blob from an AnkerMake M5 3D Printer

crwdns2936025:04crwdne2936025:0 —
Clean Heater Block After Blob Has Melted Off

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Plug the printer back in.

Power on the printer and heat the nozzle to 250°C for a few minutes to soften the blob. In many cases, the heat will melt off the blob if the extruder housing is removed.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0