Place a spudger or an opening tool under the edge of the small camera's press connector and pry straight up to disconnect it.

Make sure to pry under the edge of the connector itself, and not under the socket on the board. Otherwise, you risk permanently damaging the socket.

Work carefully: don't pry on or accidentally scrape any small, surface mounted components on the board.

Use the tweezers to remove the camera module from the board.

To reconnect, align the connector carefully over its socket and press down with your fingertip—first on one side, then the other—until it clicks into place. Don't try to force the connector into place. If you're having trouble, reposition it and try again.

Don't press down on the middle of wider connectors until they're fully seated. If misaligned, the connector or the pins underneath can bend or break, causing permanent damage.

You don't have to disconnect this specific camera. If you know which camera is faulty you may skip this and go to directly disconnecting the faulty camera.