First, power off your laptop and unplug all cables and accessories. Then, place it upside down on a stable and flat surface.

Use the T5 Torx Screwdriver to remove the twelve screws on the bottom of the laptop. Once the screws are removed, lift off the bottom panel.

Use the Phillips #0 Screwdriver to remove the twelve screws holding the heatsink in place.

Carefully pull the two black tabs on either side of the black ribbon to disconnect them from the board.

Gently pull off the inner black ribbon to remove it from the board.

Use the Phillips #0 Screwdriver to remove the two screws holding the mSATA.

With a gently tug, disconnect the four white plugs.

Use the Phillips #0 Screwdriver to remove the two screws holding the wireless card.