Heat up the bottom rubber plate near holes using heat gun or hairdryer and try to insert prying tool as adhesive softens.

A drip or two of isopropyl alcohol on the plastic tools can soften the adhesive even further

If you're using Heat Gun do not overheat the rubber plate as it may melt. You should be still able to touch the rubber plate with bare hands after heating it up.

Watch out for ribbon cables hiding in holes, as covers with T5 Torx screws are now removed.

As the adhesive softens, try to insert flat plastic tool on the top

Heat up the rest of the rubber plate and slide plastic tool along upper side of the rubber plate

The bottom side of the plate has plastic clips (third image). Trying to push plastic tool too hard in lower part may result in damaging plastic clips

Remove the rubber plate