crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Disassembling Kenwood TM-241a Face Plate

crwdns2936025:02crwdne2936025:0 —
crwdns2916944:0crwdne2916944:0

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Below where the tuning knob was, there is a 7/16" nut that helps to secure the face plate to the radio. This needs to be removed to allow the face plate to be taken off.

Behind the nut is a small washer. Be sure to pull it off as well and set the two aside so they do not get lost.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0