In this step, you will temporarily install the new screen in order to properly align it with the front-facing camera bracket while adhering the bracket to the screen.

Make sure there is no adhesive anywhere on the screen before attempting this step. You should not seal the phone closed yet.

Very carefully align the lower edge of your new display with the lower edge of the phone case.

Set the lower edge of the screen in the case, and slowly hinge it down toward the phone case, being careful to keep it properly aligned with the case.

Set the screen down in the case and press down on the front-facing camera hole to ensure that the bracket is adhered to the screen.

Lift the screen up and away from the phone case and check that the camera bracket is adhered to the screen.

Disconnect the display cable.

During the boot-up process after reassembly, the screen will go through a calibration sequence. Do not touch the screen during this process, as it could result in improper touch calibration and create touch issues.