crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Xbox One Wireless Controller 1697 LT/RT Magnet Adjustmentcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Introduction
If your Xbox One controller has LT/RT issues, the issue likely lies with the magnets. Use this guide to take the controller apart and secure the magnets so they do not move again. This guide is also useful for readers with self pressing trigger problems, since magnet adjustment may fix this issue.
== Guide warnings ==
* '''Be prepared to write off your controller if this fix is attempteddoes not work. There is a chance thisThis fix may not work or may make the problem worse. This problem is fixednot found on Model 1708 controllers.'''
* '''WARNING!''' The plastic frame can be melted if the flame is held too long or the flame is too hot. Hold it until it seals and remove the flame once the heatshrink tubing is sealed.
* '''This procedure will VOID ALL WARRANTIES. Make sure any warranties are expired or you cannot take advantage of it if you care. This controller is 17 months old.'''
== Guide notes ==
* This fix does not apply to Model 1708 controllers since these do not fail this way. This only happens on 1537/1697 controllers.
* If you misalign the magnets, you may need to replace the controller frame. Replace the frame or write the controller off if this happens.
* The magnets are covered in heat-shrink tubing. Once the heatshrink is cut, this heatshrink will need to be replaced. Be careful not to burn the controller frame when sealing the new heatshrink.