|
Introduction |
| If your Xbox One controller has LT/RT issues, the issue likely lies with the magnets. Use this guide to take the controller apart and secure the magnets so they do not move again. This guide is also useful for readers with self pressing trigger problems, since magnet adjustment may fix this issue. | | | == Guide warnings == | * '''Note: Be prepared to write off your controller if this fix is attempted. There is a chance this may not work or may make the problem worse. This problem is fixed on Model 1708 controllers.''' | | * '''WARNING!''' The plastic frame can be melted if the flame is held too long or the flame is too hot. Hold it until it seals and remove the flame once the heatshrink tubing is sealed. | * '''This procedure will voidVOID ALL WARRANTIES. Make sure any warranties are expired or you cannot take advantage of it or it is expired if you care. This controller is 17 months old.''' | | == Guide notes == | * This fix does not apply to Model 1708 controllers since it cannotthese do not fail this way. This only applies to Modelhappens on 1537/1697 controllers. | * If you attempt this fixmisalign the magnets, you may not get the alignment correct. Be preparedneed to replace yourthe controller frame. Replace the frame or write the controller off if this fix does not workhappens. | * The magnets are covered in heat-shrink tubing. Once the heatshrink is cut, the magnet will be exposed and itthis heatshrink will need to be replaced. Be careful not to burn the plasticcontroller frame when sealing the new heat-shrink tubingheatshrink. |
|