|
Introduction |
If your Xbox One controller has LT/RT issues, the issue likely lies with the magnets. Use this guide to take the controller apart and secure the magnets so they do not move again. This guide is also useful for readers with self pressing trigger problems, since adjusting the magnets canmagnet adjustment may fix thethis issue. | | == Guide warnings == | * '''Note: While your odds of success are very good, you should prepareBe prepared to write off theyour controller if you try this fix is attempted. There is a chance you will do more damage tothis may not work or may make the controller then it previously suffered fromproblem worse. This issueproblem is not presentfixed on Model 1708 controllers.''' | * '''WARNING!''' Plastic damageThe plastic frame can be done to your controllermelted if too much heat is used or the flame is held too long. Only hold or the flame as long as you need to for a good sealis too hot. Hold it until it seals and remove the flame once the heatshrink tubing is sealed. | * '''This procedure will void ANY warranty associated with your controllerALL WARRANTIES. Make sure you cannot take advantage of it or it is expired if you care about this. TheThis controller used in this guide is 17 months old and is long out of warranty.''' | | == Guide notes == | * This fix applies to Model 1537/1697 controllers. I am writing this for the Model 1697 controller since this is what I own. This fix does not apply to Model 1708 controllers (these are designed in a waysince it cannot fail this does not happen)way. This only applies to Model 1537/1697 controllers. | * If you attempt this fix, you may not fixget the alignment correctly and do more harm then goodcorrect. Be prepared to replace your controller frame if this fix does not work. | * The magnets are covered in heat-shrink tubing. Once the heat-shrinkheatshrink is cut and, the magnet is relocated,will be exposed and it youwill need to be replaced.replace this heat-shrink Be careful not to burn the plastic when sealing the new heat-shrink tubing. |
|