crwdns2915892:0crwdne2915892:0
Use this guide to replace a cracked or broken screen on your Galaxy Watch.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.
-
-
-
Use an opening tool to get between the back cover and the metal housing of the watch.
-
Carefully pry the plastic back cover open.
-
-
-
Lay down the watch and lift the back cover to access the sensor connector on the motherboard.
-
-
-
-
Use a spudger to disconnect the sensor flex cable from the motherboard.
-
-
-
Use a spudger to disconnect the display flex cable from the motherboard.
-
-
-
Lift the core unit out of the housing.
-
-
-
If necessary apply some tape over the display to avoid any injury from glass shards.
-
-
-
Use your finger or thumb to steadily push down on the display to loosen the adhesive.
-
Remove the display.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
crwdns2935221:0crwdne2935221:0
crwdns2935229:08crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Master Techs crwdns2935289:0Master Techscrwdne2935289:0
Community
crwdns2931471:0322crwdne2931471:0
crwdns2935297:02,539crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Hi does this process work with the galaxy 5 watch?
