crwdns2915892:0crwdne2915892:0
Follow this guide to remove the right-side cover of a Mi-T-M heater model MH-0190-0M10.
This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.
crwdns2942213:0crwdne2942213:0
-
-
Flip the power switch into the OFF position.
-
Unplug any extension cords from the included power cord.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.
-
-
-
-
Lift the upper shell straight up off of the machine to remove it.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the four bolts securing the right-side cover.
-
-
-
Tilt the right-side cover down to access the PCB board.
-
-
-
Use needle nose pliers to remove the wire with the blue connector.
-
Remove the wire with the clear connector.
-
Remove the right-side cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
