crwdns2915892:0crwdne2915892:0
Use this guide to open your TicWatchPro for repairs.
crwdns2942213:0crwdne2942213:0
-
-
Before starting repairs, take your watch off the charger and power it down.
-
Remove the four 3.9 mm-long Torx T3 screws.
-
-
-
Carefully lift the back cover by the watch crown edge and swing it open to an upward position.
-
-
-
-
Use the flat end of a spudger to pry up and disconnect the sensor flex cable.
-
-
-
Remove the back cover.
-
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Check out our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Check out our Answers community for help.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947412:02crwdne2947412:0
T w lte 4G. Botón power como cambiar no conecta
Mostrar tutorial (si existe). gracias
The screws at least on my unit seem to be Torx T4. A T3 will work, but be careful not to strip the screws.
Jappu - crwdns2934203:0crwdne2934203:0
Yes! They are T4 on my watch too.
Jim Bondly - crwdns2934203:0crwdne2934203:0
They're T4 on mine as well.
Jared Capson - crwdns2934203:0crwdne2934203:0