crwdns2915892:0crwdne2915892:0
Use this guide to open your Huawei Watch GT 3 (46 mm) for repairs.
crwdns2942213:0crwdne2942213:0
-
-
Before starting repairs, take your watch off the charger and power it down.
-
Remove the watch band.
-
-
-
Remove the four 3.7 mm-long Torx T2 screws securing the back cover.
-
-
-
-
Insert the edge of a spudger into the the loudspeaker opening at the bottom edge of your watch.
-
Use a spudger to pry up the rear panel of your Huawei watch GT 3.
-
-
-
Carefully swing the rear panel assembly open to an upward position.
-
If possible, turn on your device and test your repair before installing new adhesive and resealing.
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
If possible, turn on your device and test your repair before installing new adhesive and resealing.
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947410:01crwdne2947410:0
I am curious to see why the altimeter on my Huawei Smartwatch GT3 stopped working and got stuck at zero reading. That happened right after the last HarmonyOS back in June 2024.
So, I'm not sure if it was a software issue that needed fixing or actual hardware? Any though back?
