crwdns2915892:0crwdne2915892:0
This repair guide was authored by the iFixit staff and hasn’t been endorsed by Google. Learn more about our repair guides here.
Use this guide to replace the vibration motor in your Google Pixel Watch 2.
If your watch is making inconsistent or weak vibrations or isn't vibrating at all, it may be time to replace the vibration motor.
You'll need replacement adhesive glue to seal your watch during reassembly.
crwdns2942213:0crwdne2942213:0
-
-
Remove both watch bands by pressing the release button and sliding the band out of its groove.
-
-
-
Secure your watch with a small vise so the jaws go into the watch band grooves on the frame.
-
-
crwdns2935267:0crwdne2935267:0iFlex Opening Tool$11.99
-
-
Use a hair dryer or heat gun to heat the right edge of screen around the watch crown until it's slightly too hot to touch.
-
-
-
Insert the tip of an iFlex between the screen and frame just below the watch crown (opposite the side button).
-
Rotate the iFlex so its longer edge is between the screen and frame.
-
-
-
-
Hold the iFlex at a slight upward angle and slide it clockwise around the perimeter of the watch to separate the adhesive. Stop when you reach the side button.
-
-
-
Remove your watch from the vise.
-
-
-
Consider placing your watch on something soft like a clean cloth to help stabilize it and prevent damage.
-
Attach and remove the watch bands as needed to get a better grip or stabilize your watch.
-
-
crwdns2935267:0crwdne2935267:0E6000 Adhesive Glue$2.99
-
Swing open the screen and put it in an upright position next to the watch crown.
-
Use a spudger and tweezers to remove all the old screen adhesive from the frame and screen. Then, clean up any adhesive residue with high‑concentration (>90%) isopropyl alcohol and a cotton swab.
-
You'll need to seal your phone with strong adhesive glue. Apply the glue to the perimeter of the frame and firmly press the screen into place.
-
-
crwdns2935267:0crwdne2935267:0FixMat$36.95
-
Use a 1IP Torx Plus screwdriver to remove the 2 mm‑long screw securing the vibration motor press connector cover.
-
-
-
Use a pair of blunt nose tweezers to grip the vibration motor press connector cover.
-
Gently peel up the tape until the vibration motor cable is uncovered.
-
-
-
Use the point of a spudger to pry up and disconnect the vibration motor press connector.
-
-
-
Use a 1IP Torx Plus screwdriver to remove the two screws securing the vibration motor:
-
One 2 mm‑long screw
-
One 3 mm‑long screw, also securing a grounding bracket
-
-
-
Use blunt nose tweezers to lift the grounding bracket out of its recess and remove it.
-
-
-
Remove the vibration motor.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.