crwdns2915892:0crwdne2915892:0
Prerequisite guide for disconnecting the battery in the Samsung Galaxy S24+.
crwdns2942213:0crwdne2942213:0
-
-
Unplug any cables from your phone.
-
Hold the side key and the volume down button, then select "Power off" to turn off your phone.
-
-
-
Heat an iOpener and apply it to the right edge of the back cover for two minutes.
-
-
-
Apply a suction handle to the back cover, as close to the center of the right edge as possible.
-
Pull up on the suction handle with strong, steady force to create a gap between the cover and the frame.
-
Insert an opening pick into the gap.
-
-
-
Slide the pick back and forth along the right edge to separate the adhesive.
-
Leave the pick inserted near the bottom right corner to prevent the adhesive from resealing.
-
-
-
Apply a heated iOpener to the bottom edge of the back cover for two minutes.
-
-
-
Rotate the opening pick around the bottom right corner to separate the adhesive.
-
-
-
Insert a second pick at the bottom right corner.
-
Slide the opening pick to the bottom left corner to separate the adhesive.
-
Leave the pick in the bottom left corner to prevent the adhesive from resealing.
-
-
-
-
Apply a heated iOpener to the left edge of the back cover for two minutes.
-
-
-
Rotate the opening pick around the bottom left corner to separate the adhesive.
-
-
-
Insert a third opening pick at the bottom left corner.
-
Slide the pick toward the top left corner to separate the adhesive.
-
Leave the pick near the top left corner to prevent the adhesive from resealing.
-
-
-
Apply a heated iOpener to the top edge of the back cover for two minutes.
-
-
-
Rotate the opening pick around the top left corner to separate the adhesive.
-
-
-
Insert a fourth opening pick at the top left corner.
-
Slide the pick toward the top right corner to separate the adhesive.
-
Leave the pick near the top right corner to prevent the adhesive from resealing.
-
-
-
Line up the tip of an opening pick with the flash.
-
Slide the opening pick under the top of the back cover until you feel it start to snag on the adhesive.
-
Keep sliding the pick toward the bottom of the phone while gently lifting the cover until the cover is free of the adhesive.
-
-
-
Grab and remove the back cover.
-
Use tweezers or your fingers to remove all adhesive from the back cover and the phone. Use heat or isopropyl alcohol (90% or greater) and a coffee filter or lint-free cloth if you're having trouble removing the adhesive.
-
If you're using custom-cut adhesives, follow this guide.
-
-
-
Use a spudger to pry up and disconnect the wireless charging coil press connector from the motherboard.
-
-
-
Use a Phillips screwdriver to remove the thirteen 3.5 mm‑long screws securing the wireless charging coil and the loudspeaker:
-
Six screws securing the wireless charging coil
-
Seven screws securing the loudspeaker
-
-
-
Insert the point of a spudger in the notch at the top left corner of the loudspeaker, which is marked by an arrow.
-
Pry up to unclip the loudspeaker from the frame.
-
-
-
Use your fingers to lift the loudspeaker away from the frame.
-
Remove the wireless charging coil and loudspeaker from the frame.
-
-
-
Use a spudger to pry up and disconnect the battery press connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
