Why is my bed acting up?
I leveled out the bed on all 4 corners but when I get to the middle its all loose there making the filament not stick correctly
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
0
841050
crwdns2933313:01crwdne2933313:0
crwdns2934065:0crwdne2934065:0: 5.7crwdns2936485:0crwdne2936485:0
4
5
I'm not familiar with this printer, but:
- "Loose" does not describe anything I can relate to.
- Placing the straight edge of a steel ruler from corner to corner might tell you if there is a dip there if that is what you are refering to.
- Knowing how you leveled the 4 corners might help with the analysis of the problem.
- You can print a flat object from corner to center (move it from the default center position) to see if it is only not sticking in the center.
- If it also doesn't stick on the corner, your Z offset may be the problem, or your Z endstop may be loose or inconsistent.
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
0
your best option is to get a glass bed for your printer. Creality is known for their uneven or beds with a dip in the middle.
