Hey does anyone have a video on how to remove and reinstall the headphone jack, I can see 4 solder points around it but my iron gets too close and just melt the plastics, same with the hot air gun. Any suggestions, thanks
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 1.1crwdns2936485:0crwdne2936485:0
7
1
1
Flux it, use "Low Melt" solder, and lower the temp on the iron. After a little time the port/jack should just fall out. Wick away the old solder, solder in the new jack using 60/40 leaded solder.
Wait......by "melts the plastics" do you mean the controller shell?? O_o
Always remove the board from the shell before hand. :)
crwdns2934105:0crwdne2934105:0
Hey thanks for the response. Not not the shell, I take the board completely out, I meant the headphone port plastic itself. I will try what you said. Thanks.
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 3
crwdns2936753:030crwdne2936753:0 11
crwdns2942667:0crwdne2942667:0 42
