Pinout of the display connector.
@danj - By any chance do you have the pinout/values of the the display connections?
I'm doing a little bit of a mod.
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
0
800758
crwdns2934065:0crwdne2934065:0: 7,3crwdns2936485:0crwdne2936485:0
32
17
34
crwdns2933313:01crwdne2933313:0
crwdns2934057:0crwdne2934057:0
crwdns2934065:0crwdne2934065:0: 479,6crwdns2936485:0crwdne2936485:0
35
329
971
The older Unibody systems use LVDS signaling which is dependent on a dual connection for the active line. Here’s a good write up Low-voltage differential signaling.
Without understanding what you are trying to do it would be hard to offer a signal breakdown as the way it works is a bit more complex.
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
1
@danj - I'm needing to check the wire pinout, to make sure that it's the right pinout for the new display. I'm testing an ai's guide it gave me
@beanman56 - “I'm testing an ai's guide it gave me” ??
@danj - Don't ask..
@beanman56 - I was expecting a typo😊
@danj - I'm testing chatGPTs guide knowledge.
