Missing Pads Charge Port
Hello,
I am missing charge port pads for pins 5, 12, 14, and 20 for an iPad 6th Generation WIFI. Can some help me identify any test points on board where I can jump these to the connector?
Thanks in advance!
crwdns2934109:0crwdne2934109:0
crwdns2944067:05crwdne2944067:0
you need to mark the pads in the photo or picture - the numbers of pins and lines are not marked on any of the available diagrams (let's at least set the starting point and the direction of counting - so as not to make a stupid mistake). At the same time, I confirm - such a check is possible
crwdns2934271:0crwdnd2934271:0 bert.harmidomski crwdne2934271:0
I am missing the ones highlighted in light blue.
crwdns2934271:0crwdnd2934271:0 mmejia04 crwdne2934271:0
wait...
crwdns2934271:0crwdnd2934271:0 bert.harmidomski crwdne2934271:0
mmejia04 post a picture of your actual board as well. That way we can actually see the placement of the components and follow the traces as per schematic....
crwdns2934271:0crwdnd2934271:0 oldturkey03 crwdne2934271:0
I posted a new picture, the pads inside the red boxes are the ones needed. The other pads are either connected to ground or have a second connection to the same point.
crwdns2934271:0crwdnd2934271:0 mmejia04 crwdne2934271:0