How to unbend aluminum from on screen corner?
I dropped my laptop and the corner of the metal frame bent into the laptop and is slowly pulling the laptop apart.
crwdns2934109:0crwdne2934109:0
crwdns2889612:0crwdne2889612:0
0
564056
crwdns2933315:02crwdne2933315:0
crwdns2934065:0crwdne2934065:0: 13
1
You have to change the chassis. There isn’t really any other way
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
0
I just did this to my xps 13. The hinge could not open all the way. All I needed to fix it was to open the laptop slightly, wedge a smooth flathead screwdriver between the two metal covers (top/bottom) near where they contact and gently pry against the bent section to unbend it. The metal is VERY soft and did not take much effort. I used my forearm to push against the hinge to support it while I did this and there was no damage to the hinge.
crwdns2934105:0crwdne2934105:0
crwdns2889612:0crwdne2889612:0
0
Can you post some pics so we can see the area and the where the system is not lining up. Adding images to an existing question
crwdns2934271:0crwdnd2934271:0 Dan crwdne2934271:0