crwdns2934065:0crwdne2934065:0: 185
6
3
So I've been using this device for about 3 hours and within that time I needed to charge the battery. When i did that I used it again right after and while I was using it, the device seemed very hot, the battery specifically. What's wrong with my device?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 306
8
1
1
1. You used the device for a long period of time and the battery really got hot, just turn it off and use it again after 20-30 min.
2. Your fan that cools the device might be broken. The fan is what cools the device and stops it from overheating. If broken just remove the fan and add a new one in.
crwdns2934105:0crwdne2934105:0
crwdns2934065:0crwdne2934065:0: 13
1
I live in an Apartment- I found out on mine, It was my problem… I was runing it at to low of Speed. To keep the sound down….. End of my motor.
crwdns2934105:0crwdne2934105:0
crwdns2934065:0crwdne2934065:0: 1
1
They use a TO-220 MOSFET inside with a terribly small heatsink and a small glueless mating surface between the MOSFET and the heatsink with a loose rivet. The MOSFET can get too hot and blow (small puff of smoke, sparks…etc.) I just ran into this myself. I’m going to have to desolder the MOSFET(s, there is a second one beside the TO-220) and put them on a better heatsink, properly mated as well. …Conveniently a month after the warranty expires.
*Edit* For anyone needing to replace the electronic assembly inside, the part number is 2610005464.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 11
crwdns2936753:030crwdne2936753:0 34
crwdns2942667:0crwdne2942667:0 8,138
crwdns2947414:01crwdne2947414:0
My flex shaft is getting hot, not the actual Dremel. The flex spring is very hot after about 10 minutes of operation.
crwdns2934271:0crwdnd2934271:0 tim.bankes crwdne2934271:0