crwdns2934065:0crwdne2934065:0: 85
2
2
I have the original GoPro hero and the attachment clips are part of the housing case which can't be replaced or removed. I was wondering if anyone had any ideas about how to reattach the clips? Is it going to have to be a glue job?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 25
1
Here is a great solution:
crwdns2934105:0crwdne2934105:0
crwdns2934065:0crwdne2934065:0: 195
3
1
The switched output board needs to be replaced. It could have just died, or burned out from trying to pull more than it is rated for.
crwdns2934105:0crwdne2934105:0
That isn't related to the question.
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 3
crwdns2936753:030crwdne2936753:0 25
crwdns2942667:0crwdne2942667:0 8,644
crwdns2944067:02crwdne2944067:0
I have this problem too
crwdns2934271:0crwdnd2934271:0 tony crwdne2934271:0
The same here. Broke off in the water. :(
crwdns2934271:0crwdnd2934271:0 Jens Van den Eede crwdne2934271:0