crwdns2934065:0crwdne2934065:0: 92
7
6
Whenever I turn the projection clock button to the "on" position, it moves back to the "off" position and will not stay on.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 381
10
1
Hi Kathy,
Sometimes the on/off switch can get a bit loose and you might need to snap it back in place. See the guide linked below!
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 3
crwdns2936753:030crwdne2936753:0 5
crwdns2942667:0crwdne2942667:0 452
crwdns2944067:02crwdne2944067:0
After some research, I discovered that the unit needs to be reset.
Resetting process:
Remove batteries and disconnect adapter for 15 minutes.
Reinstall batteries and reconnect adapter.
Hold reset button for 5 seconds located in the battery compartment or on the back of the unit.
(A paper clip or pin will be needed to fit into the hole for the reset button.)
crwdns2934271:0crwdnd2934271:0 Kathy Rowley crwdne2934271:0
Projection Clock RM318PA Troubleshooting.
crwdns2934271:0crwdnd2934271:0 Kathy Rowley crwdne2934271:0