crwdns2934065:0crwdne2934065:0: 143
3
4
How can I remove the hold down nails {to be replace with insulated screws[from the corrugated metal roof
without damaging the metal roof? is there a nail puller
that pulles straight up and not pried up.
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 480.5crwdns2936485:0crwdne2936485:0
35
330
971
You may need to fashion a block of wood that conforms to the metal roof to spread the pressure of the hammer claw/crow bar base as you pry the nail.
I took two blocks of wood and two pieces of 1/4 steel placed across as short a distance as I could between the blocks. Then resting the hammer on the metal bar pulling the nails.
In my case I had raised over-lapping seams. If you have corrugated roofing that will be harder depending on where they nail it down.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 3
crwdns2936753:07crwdne2936753:0 19
crwdns2936753:030crwdne2936753:0 30
crwdns2942667:0crwdne2942667:0 7,711
