crwdns2862678:0crwdne2862678:0
crwdns2895503:0crwdne2895503:0
Roomba stopped moving
The Roomba stops moving in the middle of vacuuming.
Front Wheel is Stuck
If the front wheel has trouble turning, the wheel may have debris lodged in the axle. Remove the wheel and clean the wheel cavity. Also remove the wheel from its housing and clean the axle. If the wheel is still not working, it may be broken and need to be replaced.
Placeholder Text
Side Wheel is Stuck
Place the Roomba on a flat surface and restart the clean cycle. If any errors occur on a flat surface, check the wheel for any clogged debris that is preventing the wheel from moving. If the wheel still does not work, then it may be broken and need to be replaced.
Placeholder Text
Roomba is moving strangely
Constantly spinning uncontrollably or is not able to sense drop offs.
Roomba is Spinning in Circles
Pick up the Roomba and place it in the middle of the room. Restart the clean cycle. If the problem continues, the wheels could be obstructed and should be checked for debris.
- Inspect the wheels for debris.
- Manually turn the side wheels and push them down to clear any debris in the wheel wells.
- Push/tap the bumper to ensure spring compression and to clear any debris.
- If this does not solve the problem, use compressed air to clear all remaining debris.
''Placeholder Text
Roomba has decreased in cleaning performance
Will not vacuum as efficiently as before.
Brushes and/or Filter Are Dirty
The Brushes and Filter often get blocked up, which leads to a decrease in the performance of the Roomba.
Remove the brushes to clean them.
In order to clean the filter:
- Remove the dirt bin.
- Open the Dirt bin door using the yellow tab.
- Pull the yellow tab upwards.
- Clean the filter with compressed air.
- Replace the filter, close the door, and reinsert the Dirt Bin.
Placeholder Text
The Roomba's Lights Are Flashing
The Roomba's lights are blinking, displaying an error, or saying "charging error".
Blinks Once
The battery is not connected. Make sure that you removed the battery pull-tab. Once that is done, take off the bottom cover of your Roomba to reinstall the Roomba's battery.
Placeholder Text
Blinks Twice
Your Roomba needs to cool down or let it recharge for awhile while its cooling down.
Placeholder Text
Blinks Three Times
You need to reset the Roomba's software. In order to do this, hold the two buttons above and below clean simultaneously for 10 seconds, then try charging your Roomba again.
Placeholder Text
Blinks Five Times
See 'Blinks Three Times'. It can be resolved with the same solution as number 3.
Placeholder Text
Blinks Six Times
The battery of your Roomba is too warm or it's overheating so you need to let your Roomba cool down for about an hour and then try charging it again.
Placeholder Text
Blinks Seven Times
The battery of your Roomba is not cooling which means that you need to Let your Roomba cool down for about an hour and or more until it starts to charge again.
Placeholder Text
crwdns2915084:0crwdne2915084:0
University of North Texas, Team S1-G5, Thomas Spring 2020 crwdns2935289:0University of North Texas, Team S1-G5, Thomas Spring 2020crwdne2935289:0
UNT-THOMAS-S20S1G5
crwdns2931471:03crwdne2931471:0
crwdns2935303:01crwdne2935303:0
crwdns2944067:014crwdne2944067:0
Buenas tardes tengo problemas con el cepillo lateral de Romba 675 , no funciona ya lo limpie siguiendo los pasos del manual y sigue sin funcionar, ? QUE RECOMIENDAN HACER , se compro apenas en diciembre 2020. ? tiene garantía?
Jose Antonio Barrera - crwdns2934203:0crwdne2934203:0
Roomba does not dock — not recognizing docking station; runs into it and pushes it around.
Tom Breese - crwdns2934203:0crwdne2934203:0
My rhoomba is giving the error to clean brushes. I clean the brushes and restart. It runs for about 4 minutes and then stops and gives the clean brushes error again. What do I need to do???
Donna Baker - crwdns2934203:0crwdne2934203:0
My roomba is brand new. It only spins in circles and does not move.. what can I do? I have already bumpped the bumpper, checked the wheels for debirs… it states error 9 nothiing works
Bertha - crwdns2934203:0crwdne2934203:0
675 wont charge.
Jack Fraser - crwdns2934203:0crwdne2934203:0
Jack,
I have the same problem. it just keeps saying “charging error 8”. I have reset it several times, pulled the tab off the battery, removed the bottom and then removed the battery and reinstalled it, but nothing. Sure would be nice to get an answer, wouldn’t it.
Donald Friends -
My Roomba 675 keeps saying” error 1 please move Roomba to a new location”. But it won’t quit saying it and won’t work . What can I do to fix this issue?
brenda reck - crwdns2934203:0crwdne2934203:0
Roman keep saying move to new location and restart. So what is the problems?
Hanh Tran - crwdns2934203:0crwdne2934203:0
Buenos dias mi roomba 675 no carga. Solo esta parpadeando el boton de clean.
Que puedo hacer?
jaime lozano - crwdns2934203:0crwdne2934203:0
My iRobot 675 timer isn’t working. I scheduled 15 minutes cleaning time. It runs until battery dies
Debra Williams - crwdns2934203:0crwdne2934203:0
Roomba 675 was working fine until it stopped in mid-cycle and went completely dead. Won't charge, no blinks nothing... Tried it on two different chargers and same deadness. Took out battery waited 30 seconds and re-installed...nada. Then checked battery in different Roomba where it worked fine. Is there an internal flash or something that is not getting power?
Max Q - crwdns2934203:0crwdne2934203:0
Brand new out of box and charged roomba 675 only turns in circles after disconnecting from dock. Have tried resetting and nothing is blocking wheels. It started doing this as soon as it left the dock first time. Does not matter where in the room it is.
anteek432 - crwdns2934203:0crwdne2934203:0
My rhoomba is giving the error to clean brushes. I clean the brushes and restart. It runs for about 4 minutes and then stops and gives the clean brushes error again. What do I need to do???
Camille D Nasca - crwdns2934203:0crwdne2934203:0
My Roomba starts and then it clicks off
Ruth - crwdns2934203:0crwdne2934203:0